Patio Door Maintenance Tips – Combating surface condensation.

Where surface condensation is evident it should be considered as a warning sign. However, each person has his or her own level of personal comfort and the amount of condensation they are willing to accept, to maintain that level. If the occupants insist on a high level of humidity within the house, surface condensation must be expected when outside temperatures are low.
Some indications of surface condensation are:

Why should you care?

If left unchecked, a condensation problem in your home may cause rotting, peeling of paint, and the deteriorating of insulation and even buckled floors. What can you do about it?
There are many possible solutions to the problem of condensation. If one solution doesn’t eliminate the problem, try another – or a combination.

Measure the moisture

Some humidity is necessary for comfort and health. With many houses it is a struggle to keep enough moisture inside the house and maintain an acceptable comfort level for the occupants. Frequently humidifiers are installed to add moisture to the air but their use must be controlled or surface condensation problems may result. Unfortunately a dry house may indicate a high leakage rate (depending on the amount of moisture added by the householder) and contributes to concealed condensation. In some of the new homes, however, air leakage has been controlled to such an extent that the problem really is how Ito get rid of moisture. Yet many householders go on adding moisture to the air. The danger signal of condensation on windows, mould growth, or the damp spots on ceilings and room-side surfaces of exterior walls do not discourage them. Because windows do not provide much resistance to heat loss, they are often the coldest component of a building enclosure, and can be an indicator of humidity problems. As condensation occurs on inside window surfaces, whenever surface temperature falls below the dew point temperature of the room air, it may be a warning signal to reduce the humidity in your residence.

What can affect the performance of your windows? 

The following may cause condensation to form on a window at lower levels than given in the table.

Air Circulation

A window may be in an area in which there is poor circulation of warm air. This means that the temperature of the inside glass surface is colder than in other parts of the home and this may cause condensation to form at humidity levels which are practical for the rest of the home.

Drapes

The figures in the table below are based on natural circulation of warm air on the inside surface of the window. By drawing heavy drapes or Venetian blinds over a window or patio door the possibility of condensation can be increased because the flow of warm air is restricted.

Varying Humidity Levels

Remember that the humidity in some rooms, kitchens and bathrooms in particular, can be higher than in other areas of the home, thus encouraging condensation to form on the windows in these rooms.

Orientation

If windows are exposed to prevailing winds, then they will be slightly colder than the other windows in the home and may cause condensation to form at humidity levels which are practical for the rest of the home.

Exposure

Some windows in the home may be protected by other buildings, trees, etc., which form a windbreak while others are totally exposed to the wind and, therefore, colder.

Wind Chill Temperature

Traditionally this has been the method used to relate wind and temperature. Usually traditional temperature readings do not include a wind chill factor. For example, with an indoor temperature of 20 decrees C and an outside air temperature of -12 degrees C the table below recommends a relative humidity of 30 percent. However, with an outside air temperature of -12 degrees C and a 20 kilometer per hour wind the outdoor wind chill temperature is -26 degrees C and so the level of relative humidity should be reduced to 20 percent.

How to Control the humidity in your home?

Ventilation is the most effective means for the house resident to remove moisture. By exchanging some of the drier outdoor winter air for warm humid interior air the moisture level will be reduced.